• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

Yocan Cylo?

D

DrFog

Rising Star
Has anyone had success with the Yocan Cylo? I have several devices including the Yocan Orbit, sub ohm tanks and E-mesh which is awesome but I can’t get the Cylo to work. Would love to hear comments and suggestions?
 
Success, its a hard skill to get down. 3.5 setting and hit it low and slow and just get as much volume in your lungs as possible. there is an element of throttling the button when it gets too hrsh but slow full long hits and hold them in as long as you can. My experience took me 3 good long big hits and bam - first breakthrough.
 
yatyas314 said:
Success, its a hard skill to get down. 3.5 setting and hit it low and slow and just get as much volume in your lungs as possible. there is an element of throttling the button when it gets too hrsh but slow full long hits and hold them in as long as you can. My experience took me 3 good long big hits and bam - first breakthrough.
Click to expand...
I noticed your settings changed in another thread (2.8v). How often is the button throttled? It seems like vapor doesn't start until about 4 seconds of holding. I honestly had to relearn how to get it vaporized compared to the evolve plus (literally burns if you hold the button for longer than half a second, so constant throttling)
 
Skeome said:
I noticed your settings changed in another thread (2.8v). How often is the button throttled? It seems like vapor doesn't start until about 4 seconds of holding. I honestly had to relearn how to get it vaporized compared to the evolve plus (literally burns if you hold the button for longer than half a second, so constant throttling)
Click to expand...
It's been a moving target, I have one other person who has the same setup as I do and I have had it as low as 2.8 (on accident) and got low vapor quality with no throttling. currently @ 3.2 with about 2 second on and then off for 2 until the mesh gets hot usually about 2-3 cycles then just a quick tap to keep it going as I inhale. My peer is trying a newer method where he doesn't even touch his lips to the mouthpiece and sets it at 3.7 slowly inhaling drawing in the vapor, 2 second button hold with a three second off cycle. He messaged me last night and reported that 3 hits and he blacked out. I hope to give it a shot tonight!
Y
 
Update @ 3.5 two second throttle with three second off then repeat as you slowly inhale. the frequency changes as the ceramic gets hot but use the throat as guidance with the strict 3 second between power bumps. I was so confused after 3 hits I took a 15 second break to get my bearings to enough to get the 4th one in. zero harshness.
 
Update: got some new coils and its like night and day. Now that I have the settings somewhat figured out the new coil was like a complete different experience. when the coil is fresh there is no layer of unused and burnt deems at the bottom restricting airflow and temp control. the longer you have the coil in service the hotter you have to set the rig for the same effect. with a new coil 3.0 is almost too hot with 2 second throttles to start and just let the vapor density dictate how many pulses you need.
Good luck.
Y
 
Back
Top Bottom