Trippyguyy96
Esteemed member
So I've been extracting for a lil while now, and iv yet to have any yields that are solid crystal chunks and I don't know what I'm doing wrong. Iv done mud pie tek and stb . I usually freeze precip but I tried to just evaporate the naptha the last few times. And I do get a yield. But it's always just tiny grains all spread out across my Pyrex dish. Could it be not using enough bark or am I doing something wrong somewhere else. For stb like my last one I used 100 gs ground bark with 1000 ml distilled water and used enough lye crystals to get a of 14 and then if usually put another half tablespoon in for good measure. Then after all was mixed and settled I slowly added the bark and gently mixed it till it was dissolved decent enough. Also I was using a pretty large mason jar with the metal lid flipped upside down so the rubber seals wasn't coming into contact with the solution. Id roll and flip the jar top over bottom for a few minutes, let it settle, then repeat. I even started basting with a glass baster the solution from the bottom and squeezing it out down the inside of the rim of the jar so it would spread scross the glass and come into contact the my naptha. Then I just pipetted it off and did a sodium carbonate wash and then separated my naptha and put it into my 8" by 8" glass dish in front of a fan. And I just get a flat layer of dmt. I just want to figure out how to get larger 3 dimensional crystals. Anybody out there who has yielded that type before, what your secret?