So I'll be the first to admit I know next to nothing about about any of this, maybe less than that. I do a lot of reading on here but still don't feel that I know enough, so I'm extracting from mhrb stb method, probably done 15-20 extractions with 5-6 pulls on each. Was using vm&p naptha for my nps and then went to bvv lab grade heptane . The only way I use my final product is through a subohm vape with very good results at first, no matter if I freeze or evaporate now I end up with solvent still in the product, I started off only evaporating with good results somehow, but not now. Before within a few hrs of pulling out of freezer it was ready to go . I'll freeze it then dump excess solvent put lid back on and upside down in freezer for another hour or so take out put almost upside down with fan blowing past it very lightly for couple hrs then scrape it out and chop it as fine as I can get it let it sit another few hrs and seems dry by then but it's not. If I try just evaporating it it's just goo which used to work fine, even better than crystals bcuz it mixes right into vape but now no matter what it's holding solvent. I live in az and it's about 110-115° outside and I'm working in a garage/outside you would think it would dry instantly almost. What can I do differently? Also is there anyway to pull the DMT back out after it's been mixed with vape juice? I have a growing collection of this now. Any help would be greatly appreciated.
-
Members of the previous forum can retrieve their temporary password here, (login and check your PM).
Can't get solvent out of my final product, so disappointing!
- Thread starter 36jere602
- Start date
Hi , what is it about your final product that make you feel it has naphtha still in it once dry . ?
You seem to be going it ok and VM&,p is generally good naptha . So can't understand what's wrong ?
For me , After I remove mine from freezer and discard naptha , and scrap and remove , I leave for at least a couple of weeks - month before using it . But Every other day I chop it up and move it around , making it fine powder .
Less places for naphtha to cling to , untill I'm sure enough all naphtha has gone .
I don't know if this is the right way to do? it but it's the way that works with me .
Sometimes I'll make a fresh batch months ahead of needing it , just to be sure
You seem to be going it ok and VM&,p is generally good naptha . So can't understand what's wrong ?
For me , After I remove mine from freezer and discard naptha , and scrap and remove , I leave for at least a couple of weeks - month before using it . But Every other day I chop it up and move it around , making it fine powder .
Less places for naphtha to cling to , untill I'm sure enough all naphtha has gone .
I don't know if this is the right way to do? it but it's the way that works with me .
Sometimes I'll make a fresh batch months ahead of needing it , just to be sure
You could try vacuum dessication. Heptanes vapor pressure is 4.5 kpa at room temp. If you vacuum the atmoshpere below that level, heptane will boil. You can get a vacuum pump from a hardware store for less than $100 that reaches that. Dmt wouldn’t even melt at that pressure at room temp.
Last edited:
