DMT in a Mechanical E-Cig Tek

[kezsel]

The general principle is stl with subohm because of amount of vapor and wide bore drip tips, and since for spice I'm using 1.6ohm, it's mtl for me

 

[TheGunslinger]

TheGunslinger, you drip your drops in the atty like normal ejuice, just figure out how many drops and how many puff to not burn the cotton, or start with a normal ejuice and when it's almost finished drop your dmtliquid. you can have one atty only for the spice and one for normal vaping.

Yeah what I do is soak the bottom cotton with regular juice and then juce the coils with my dose per drop dmtjuice so when i vape all the dmt ill just start vaping the reg juice, no waste, no dry hit. Also I use Rayon Cellucotton so Its REALLY hard to get a dry hit anyhow

 

[xa]

hi to all, there are also more wire to test, recently i buy a 50 stainless steel 310 wire get very hot in sort time it's more reactive than khantal...i'm use it with normal ejuice in dripping and it's good...also can be temp regulated....

 

[TheGunslinger]

hi to all, there are also more wire to test, recently i buy a 50 stainless steel 310 wire get very hot in sort time it's more reactive than khantal...i'm use it with normal ejuice in dripping and it's good...also can be temp regulated....

I pretty much just bought an unregulated mech mod from my friend to drip elf juice, (and experiment with nicotine) do I need to regulate temp in anyway for greater efficiency??

 

[kezsel]

Efficency is the same with all set-ups. Stronger setups require less tokes but get through more liquid, while weaker ones takes more vaping but are very easy on liquid, they also allow you to wet your feet before diving in.

 

[xa]

hi to all,

I have some goo from an mhrb eco tek, also the goo dissolve well in PG.
I made a 221 mg of goo in 20 drops of PG and added 10 drops of PG....maybe is too diluited but it's only a test, i didn't try yet, i plan to use a single coil 0.5 in a dripper with little ball of cotton...