extraction now changa

[SWITCH915]

Hello all, great forum as I have been lurking for awhile and reading.
so swim extracted down 100 gs of mhrb into a little amount of slightly reddish liquidy goo. swim used q21q21 tek. swim needs to evap it a little bit more to get the vinegar out. swim wants it to be real gooey then mix it with some herbs for changa like others have mentioned. swim is curious about dosing. can you take a bigger hit than you need to if you have more than enough material loaded or can we only take so much of the spice at once. I just dont want to have too much loaded if thats possible. is that even a bad thing??:shock:

 

[gammagore]

It doent take much 1:1 changa to blast off. One slow long rip of the bong and im off.

Ive never used the TEK you talk of for changa, but here goes: how are you going to get the DMT goop to evenly distribute over the herb, if its not evenly distributed you are bound to get a BIG surprise when smoking it.

just start with small rips first, and work your way up.

I dont think its a bad thing to have too much changa loaded, i just blank out if ive vaped too much, but everyone is different.

 

[damon]

Yes, it could be a bad thing, don't do that. Measure!

You don't want to just go off taking as much as you can. You can load it up if you just want to take small puffs. Changa is great that way too.

 

[SWITCH915]

what would be the best way to distribute the goo and herbs. the goo is in a small jar. i planned on just throwing in the herbs and mixing it up.
how exactly are you suppose to soak the mix in the alcohol? when you do the 1 to 1 ratio, do you just put in equal spice to herb, or in swims case goo to herb? swim will be using caapi vine till he gets in some caapi leaf. sorry if im sounding noobish but swim feels these journeys could answer many questions on life I have deep down inside and want to do this correct. again thanks for all your help

 

[RigelL]

Hey Switch!

I am NOT the most experienced person but from what i´ve done with jungle spice (goo like, i´ve got great results dissolving the spice onto warm acetone, still i had to dissolve the spice firt and only after i added the herbs. Then evap for 3 days and all was good
Also 1:1 means exactly the same quant of spice and herb (or herbs). Then when you try your changa don´t forget you have to multiply your normal freebase quantity to double. 50mg of freebase correspond to 100mg of changa.

Peace

 

[SWITCH915]

so swim would put in the acetone(would iso work?) into the goo first? or do i mix the herbs with the goo then add the acetone?

 

[soulfood]

I have a petri dish that I lay my leaf in after it has been processed to a suitable size. I then spread it out evenly. It's good to have the layer as thin as possible, but to completely cover the bottom of the dish so you don't have too much spice stuck to glass when you are finished.

Then I weigh out the spice and desolve it in the smallest amount of solvent I can. This is then poured onto the leaf, after which an excess of solvent is added, just to make sure all of the leaf is covered. I then leaf this for 24-48 hours or until it has dry solid.