• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

Hello everyone !!!

Franklin2100

Esteemed member
Joined
Jul 1, 2024
Messages
106
Merits
179
I have a question ,
Ok, so I haven't been around Dmt in years and im just now getting back to a healthy and normal routine .
My question is this ;
1. If I freeze the soup or just the solvent with the spice in it and if I take it our after about 3 to 4 hours , will I then be able to freeze again no problem after leaving it in room temperature for like a day after not finishing the freezing process?
thanks
 
Also make sure you dont leave it uncovered if you are going to do this or it will evaporate. The dmt like the above comment said will reabsord into the naptha at room temp, but as long as you have it covered with some foil and a snap lid or a lid that doesnt react with the naptha that is airtight you can keep it out at room temp and refreeze when youre ready to. It will crash out all the same. Unless you decide to cool it slowly or slow evap which will result in better crystal developement but in the end it is still going to be DMT in the dish. Just preference.

Hope some of this info helps and have a great day!
 
Also make sure you dont leave it uncovered if you are going to do this or it will evaporate. The dmt like the above comment said will reabsord into the naptha at room temp, but as long as you have it covered with some foil and a snap lid or a lid that doesnt react with the naptha that is airtight you can keep it out at room temp and refreeze when youre ready to. It will crash out all the same. Unless you decide to cool it slowly or slow evap which will result in better crystal developement but in the end it is still going to be DMT in the dish. Just preference.

Hope some of this info helps and have a great day!
It did .
I was thinking about the same but a good reassurance from this community really gives that peace of mind .
Thank you for the pro tips and advice fellow traveler 👋
 
Also make sure you dont leave it uncovered if you are going to do this or it will evaporate. The dmt like the above comment said will reabsord into the naptha at room temp, but as long as you have it covered with some foil and a snap lid or a lid that doesnt react with the naptha that is airtight you can keep it out at room temp and refreeze when youre ready to. It will crash out all the same. Unless you decide to cool it slowly or slow evap which will result in better crystal developement but in the end it is still going to be DMT in the dish. Just preference.

Hope some of this info helps and have a great day!
One more thing , I forgot how I did (x
Is it better to heat the soup with the Naptha or without the Naptha in it ?
Heat in Hot Water .
To heat the soup then add the Naptha or To heat the soup with the Naptha ?
To be or not to be ?
 
I give it a bit of a warm water bath when mixing the naptha. I dont like to go too hot though, you could do all of it at room temp but ive noticed I get more from the pulls with a slightly heated water bath. If you have a therm lazer keep it to around 80-90F you also want to make sure to release pressure slightly when mixing.
 
I give it a bit of a warm water bath when mixing the naptha. I dont like to go too hot though, you could do all of it at room temp but ive noticed I get more from the pulls with a slightly heated water bath. If you have a therm lazer keep it to around 80-90F you also want to make sure to release pressure slightly when mixing.
Im still pretty surprised that not that much heat is needed. It just shows the delicacy of the whole process being easier than thought and yea , when I mix it I make sure to release pressure in intervals.
Thanks again for the advice.
God bless
 
I wouldnt go above 112F but experiment with it and see what you like. Heat increases the solubility of the naptha allowing it to hold more DMT and lowers the crash out threshold similar to making rock candy
 
Last edited:
I wouldnt go above 112F but experiment with it and see what you like. Heat increases the solubility of the naptha allowing it to hold more DMT and lowers the crash out threshold similar to making rock candy
Nice to see you here! Yeah, that temperature (which some of us might recognise as being in the ballpark of 46 °C) is the low end of the melting point ranges of DMT. Using hotter naphtha than that while aiming for saturation leads to the risk of molten DMT goo crashing out on cooling. This won't be desirable if aiming for crystals.[Just to add a little further technical background to the sound advice.]
 
Back
Top Bottom