Is this tek good to use?

[flyinflyout]

swim was originally going to use natureboys tek on shroomery which takes about 3 days to complete but came across this while reading other info. Does this tek seem reasonable, will swim get a decent yield using this method?

100gr Lye
100gr Mimosa
800ml Water should be perfect
I use between 75-100ml naptha each pull

What you want to do is take water put in jar
add lye
stir up and wait for it to fully dissolve

add mimosa

shake/stir and mix up well for the next hour

(i always allow it to settle for an hour before adding naptha)

After that heat up a pot of water (not boiling hot)

add naptha 75-100ml naptha to prepared jar

shake up very well for 15 minutes

Put in pot of warm/hot water and allow to sit for a full hour

Then let that sit for another 6 hours

After that pull out the what should be yellowish naptha layer

put in another jar or any glass container that will hold it and fit in a freezer

Put that in a very cold freezer (I use my deep freezer in my garage)

Let that sit in the freezer for at least 6 hours as well

Then you should have some crystal DMT winking at you after the process is over.

This works everytime for me without fail, but I've been doing this for awhile now
you'll get the hang of it, Just be patient and it will pay off.

Does swiy think this tek should yield good results?

 

[gammagore]

A few additions to this tek

800ml water might not be enough, if you are using pre-powdered mhrb you will want to use more water, with 800ml it will probably still be very sludgy. Nomans tek calls for about25-30ml water per gram of bark. 2lt or about works for me.

75-100ml naptha is way too much, you want to use say 40-50ml naptha per pull and do say 5 pulls(or pull till nothing more comes out). So stir in the first 40ml of naptha, dont shake it, just roll it over. let it separate( should take say 10min or so) stir it up again and let separate, do this a third time and after its separated then pull the naptha out( here you can either a) freeze precip the pull while the next batch of naptha is soaking in the mhrb soup or b) collect all the naptha pulls and freeze precip together). Add the next 40ml naptha and repeat what you just did with the first pull, but this time allow the naptha to sit a little longer. Repeat this process about 5 times or till no more dmt is migrating over to the naptha.
You could also warm up your naptha a little before you add it to the soup(warm naptha pulls more dmt but also pulls more oils).

One last thing, using a mason jar with a wide mouth make life very difficult when you try and get the naptha out. I like to use then HDPE milk bottles, the neck is narrow which makes for less surface area for the naptha to cover which makes it easier to suck up the naptha. Although sucking up some of the black soup along the way isnt a problem, just siphon off the naptha into some sort of thin tall shotglass. Then you can just let the black sludge settle and decant the naptha out of the shotglass into your freeze precip container, beeing sure to leave the bkack soup in the shotglass. Hope that made sence

If you run into any problems just shout, their are plenty a helping minds here.

Oh ya, try not to fall over when you see that snowglobe of dmt in the freezer. That has got be one of the most rewarding feelings of the extraction process.

And, read through this Noman's tek - DMT-Nexus Wiki

 

[flyinflyout]

dude swim wants to thank you so much. swims really nervous/exciting to be finally pulling this off after waiting for so long, im sure a lot of people can relate to that. btw swim is using 100g of shredded bark, would 800ml be appropriate for that?
does nomans tek produce a good yield?

 

[E-Z]

I would really recommend this tek. 2nd 100g extrct - uber pictures :shock: - STB - Welcome to the DMT-Nexus
That's what I used my first time and it went very well. I agree with gammagore, use more water and less naphtha. I would recommend 1500ml of water and 50ml of naphtha.

 

[marleyman]

I would really recommend this tek. 2nd 100g extrct - uber pictures :shock: - STB - Welcome to the DMT-Nexus
That's what I used my first time and it went very well. I agree with gammagore, use more water and less naphtha. I would recommend 1500ml of water and 50ml of naphtha.

Both these follks have you on the right track, the only thing I would add is that if you use HDPE milk jugs the easiest way I've found is to just squeeze the jug until the naphtha is all the way at the top and then pull it off with an eye dropper, made things incredibly easy for me .