Making a Machine without drill bit?

[Angel_Above]

Is it even possible?

I have heard of lightbulb vapes, and tried it once, but the smoke was way too harsh in comparison to my oil burner.

My oil burner is no longer with me, and I cna't find a place to buy one. I called every pipe shop around me and the one I bought it at no longer sells them.

I tried making a machine before out of a large hot sauce bottle, but when I tried to get a hole in the bottom using a screwdriver and brute force, I ended up cutting myself and making a mess.

I have a dry pipe, but I'd rather not smoke DMT out of it because I use it to smoke marijuana.

Any help?

 

[Dimitri-Trance]

You can use a stem piece for smoking bowls of herbs.
I use one with the other end taped with a straw...the other end open as were you also load up the spice.
about in inch deep inside just so you wont burn it on the tip of the opened end.
Use a torch lighter as well for best results of huge vapor!

Swim usually breaks trough with one toke on the light bulb!

 

[amor_fati]

Try one of these instead:

amor_fati's Mini-Machine Bubbler Stem

"The (mini) Machine" Step by Step Guide

Otherwise, SWIM hears tell that it's much easier to file a hole in the corner of the bottle's bottom than to drill through the middle.

SWIM sincerely suggests against the use of a bulb oiler.

 

[MagikVenom]

Yes
No bit needed be careful punch a hole. search my previous post for details. Or just do it it will break the bottle or it will work 50/50 I like those odds.

Peace
MV

 

[Oncewas]

Hi Angel your from the shroomery right? I'm Smaerd over there.

Sorry to totally make a post unrelated to the thread but it seems like everyone else covered the rest except:

Make changa instead, it's easy, a lil more discrete, powerful, and can be smoked in a flipping joint!

Take care.

 

[Dimitri-Trance]

Try one of these instead:

amor_fati's Mini-Machine Bubbler Stem

"The (mini) Machine" Step by Step Guide

Otherwise, SWIM hears tell that it's much easier to file a hole in the corner of the bottle's bottom than to drill through the middle.

SWIM sincerely suggests against the use of a bulb oiler.

I was looking for these vaporizers instructions to post in this forum.
These should be easy to make and they work like a charm!
Nice