Micro extractions?

[Th3k1d93]

How feasible is doing a very small extraction on say 15 grams of bark? I've got plenty of materials, I'm really just not trying to go overboard at the moment. I don't have a whole mess of time available in the next couple days, but i'd really like to have a small amount of finished material by tomorrow night for the weekend. Is it as simple as just reducing material required in ratio, or without high end glass access would it make recovery too difficult? I could do it right over the weekend with a proper setup, but if i did in the next couple days it would be a kitchen tek. Thanks in advance

 

[brokedownpalace10]

I do STB and I've only done a few 20g extractions. It enables me to learn without using too much bark and, importantly, I can then do it over a few days in an hour or two each morning.

It also enables me to freeze precipitate in a small mason jar right in the freezer with food. Small mason jar in a tupperware container and I haven't had any contamination of the food yet.

I think I have some good MHRB since the second of those extractions wasn't a bad yield. However, I did one with ACRB and the yield was disappointing.

So, sure you can do it. Yield might be small.