Microdose DMT Using 510 Cartridge

[YaBoiWheel]

I have an N,N Dmt vape cartridge that is compatible with 510 thread batteries. The cartridge is 1mL and is listed as containing "50-60 Profound Journeys." I'm not sure if profound means breakthrough or not. This will be my first time using DMT. I have used 510 cartridges for cannabis before.

I am wondering if anyone has experience with these cartridges for DMT and the best technique(s) would be for microdosing or sub-breakthrough dosing in this way. I don't think I want to breakthrough to start.

More specifically, what battery voltage setting would be best and what would be a good starter inhalation technique (inhale duration, number of inhales) for a threshold or light experience.

The instructions and common knowledge state 3 large back to back hits, holding in each for 15 seconds for a breakthrough experience.

I was thinking of starting with 1, 5 second pull held in for as long as I can. The voltage range on my battery starts at 3.3V and goes up to 4.8V (I may purchase a different one if necessary).

Any information is greatly appreciated!

 

[fractals4life]

Start low with the voltage and increase slowly, as and when you find it necessary to get more vapour in you to reach where you want to go.

You can't hurt anything with too low a voltage, but too high, with too little air flow, and you risk boiling the wick dry and burning it.

Too low and you might waste a little vape juice because it's sub threshold of effects, but you'll still likely feel "a bit trippy" even if you don't see anything.

There's hardly any tolerance build up with DMT, if any, so you're good to try again as soon as you think the effects have worn off, it'll come back in ever decreasing waves after the first peak.

Start inhaling shortly before you hit the button to avoid overheating, take it in deep, hold it for a good few seconds. You'll very soon be able to judge the effect as it will hit almost immediately. I find the exhale is usually where it starts to notice.