Newbie Basic Questions (I already read the FAQ)

[spiritualdensity]

All of the questions below are within boundaries to Q21Q21 tek2.
I read the FAQ, skimmed over search results, and read the wiki but I still have lingering questions. I apologize in advance if the answer is obvious or already answered before, I am very new to this and would greatly appreciate your help!

Question 1.

General terms...
What is spice?

Question 2.

In Q21Q21's tek 2 in the non-polar wash.

What exactly is a pull?
When it is directing the user to use Naptha...

Step 1: Put the top/smaller bowl into the bottom/larger bowl and add enough boiling water to the BOTTOM bowl to match the level of the bark in the top bowl, either that or just until the top bowl floats. This is very simply to warm the naptha indirectly and safely.

Step 2: Add enough naptha so you can see it on the sides. It should be 1ml naptha per 1g of bark or more (100ml naptha or more for 100g MHRB) The naptha should stay completely separate from the bark and remain transparent.

Where does the naptha go? Inside the smaller bowl with the bark?

Question 3.
Yield.
Okay, so hypothetically 100 g of MHRB should yield about how many grams of DMT? What should I expect doing this for the first time?

Question 4.
Smoking the machine.
Where does the DMT go? I searched this up but I can't make the connection from using the mesh wire to smoking. Where the DMT goes is never explicitly stated.


Again thanks. I apologize in advance for my naivete . :?:

 

[Du57mi73]

Q1: Spice is dmt.
Q2: a pull is when you add your naptha to the basic liquid then seperate it.
Q3: 100g mimosa can yeild anywhere from .5g to 2g depending on what you do.
Q4: never used the machine but I assume you put the dmt into the mesh and then place the mesh at the stem. The mesh is used to properly heat the dmt without destroying it.

 

[spiritualdensity]

Q1: Spice is dmt.
Q2: a pull is when you add your naptha to the basic liquid then seperate it.
Q3: 100g mimosa can yeild anywhere from .5g to 2g depending on what you do.
Q4: never used the machine but I assume you put the dmt into the mesh and then place the mesh at the stem. The mesh is used to properly heat the dmt without destroying it.

For the naptha, it goes ontop of the spice liquid and subsequently mixed? Or is it poured over the spice and the bowl is subsequently mixed around the warm water?