• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

Newbie, with DMT..

Migrated topic.
Motumz

Motumz

Michael
Hey guys..

I've actually been lurking on here for quite a while until I finally found out I had to post here first haha.

But I've recently come into possession of DMT. I am extremely excited about it, but also very cautious. This might indeed be my only chance to smoke it in a very very long time. So I want to get it right the first time I smoke it.

I have around 100mg's.. (I was told) So that should be good for 2 trips?

I have been researching a lot and just came to the conclusion that I should just buy an oiler.


I was thinking I'd post my technique so others could correct me and guide me through this. So, I'd put around 40mg's in the oiler. Not really sure how I'd weigh it, but I guess I'll just do it by sight. I'll then proceed to melt it by holding the flame 4 inches away and just get closer as I seem to find a good melting spot. I then to make sure it's all melted, hold the flame under the bowl and get it nice and even. Once I get it melted I hold the flame up to the bowl and inhale. Then hopefully trip!

How does that sound?

Is there anything I should do before smoking DMT? Smoke a cig? Meditate / clear my mind? Any tips or comments would be greatly appreciated!


Also, I do own a bong that I could possibly smoke out of, but I'd rather not stink it up with DMT. I heard the stink sticks. And combining it with weed to sandwich it.. ehh.. I'd rather be quite sober while on my DMT trip. But as I said before, any techniques or comments are very welcome.


Thanks for your time! :d
 
It would be much easier to use the sandwich method if you don't have much practice using an oiler, don't worry about stink sticking - you want to use the little amount you have wisely, not be pedantic about smell. I always did an alternative to the sandwich method where by I would put a layer of herb then the DMT and that's it. I would then hold the lighter away from the DMT and slowly melt it, not sucking through or anything but just holding the flame near but not to close to the DMT and after a couple of minutes the heat would start to break it down. I would do this till I could SEE that the DMT had melted and then proceeded to smoke the cone very slowly making sure I got every last bit of DMT vapor out of the cone. Sometimes after the initial heating I would still have to suck through the bong slowly at the start just to pull the heat through the DMT and melt it completely. You need to make sure you smoke it slowly and hold the smoke in for at least 15-20 seconds!

I'd suggest just splitting the amount you have into a 1/4 and a 3/4 that way you can have the small dose first to gauge the strength and then decide whether the 3/4 dose would be too much/less. Of course though you can do it your own way. However, you will need to buy some sort of herb as you don't want to use weed and I'm assuming you're only other option would be a tobacco and you don't want to do that either. Check out this thread for a list of herbs and try and find a herb shop near you which might sell the one you'd like, or alternatively order some through a vendor on the net.
 
You can't eyeball 40mg so good luck. You would be better off trying 20mg first if you don't know how it will effect you.
 
I guess I will try the sandwich method. I was going to try to use chopped Calea leaves, but it is to harsh. I think I will just use weed. I will just buy some good pop, then wash it with water and dry it and hopefully it will just be weed with no THC on it.

If that doesn't work, then I'll buy an oiler.

I also have Salvia 40x. I would prefer to use that, because the smoke is quite smooth to me. but Salvia would fuck the trip up to me. Salvia and DMT seem so much more different. I want to be sober haha, like I said before. But if I have to be a little high, that's okay.


Also, could someone recommend me or something? I'd really appreciate the community more if I could actually comment on other people's experiences and so on :D
 
The best way SWIM found for smoking is with a vaporgenie pipe, by far.. Its REALLY smooth and effective.. just vaporize some weed before (not necessarily same day) a few times to get the feeling of how it works... stack many screens and put dmt on top of some herbs so it doesnt melt through (or make some changa).. SWIM usually uses mint and passiflora for herbs.

otherwise the sandwhich method on a water bong works ok too

btw, why dont you extract it yourself, and then you dont have to worry about having only 100mg ? :)
 
^^^^^ what endlessness said..the vaporgenie is absolutely awesome for vaporizing spice...and yea...make your own..

and eyeing 40mg from 100mg wouldnt be too hard at all...
 
Hmm that's a tricky one trying to eyeball a dose from maybe 100mg. As said before, quater that pile you have.

But I must third the VG, it trully is a masterpiece for spice vaping. If no VG is available, changa should be made and smoked through a bong.
 
Ohhh shit I totally forgot about my vaporizer. I can just vape some weed, then use that as the herb that I'll sandwich the DMT with! :D

Do I melt and smoke it the same way tho?

Like melt the DMT, then just take a normal hit? Or?
 
Motumz said:
Ohhh shit I totally forgot about my vaporizer. I can just vape some weed, then use that as the herb that I'll sandwich the DMT with! :D

Do I melt and smoke it the same way tho?

Like melt the DMT, then just take a normal hit? Or?
Click to expand...
Use a jet lighter to melt it from far away and take it slow because it burns really easily. Infused leaf is harder to screw up. Good luck.
 
Back
Top Bottom