• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

vaping rue seed..[ under SP]..

Migrated topic.
Thank you! I don't have a fancy S&B but a simple dry herb vaporizer that has capsules, I might drop 5-8 in and just try.
Temp: 225c ?
I think the secret to better vaporization is .....slower aplication of the right temperature ....like the ...plenty...took...1 to 2 minutes as it heated up at a slower genteler pace

...reducing the chance of burning the material...and causing a good compleate vaporization of product...and high quality vapor...

most hand held vapes alow a ...10 second heating cycle.... then the mod shuts off to prevent overheating ..then to continue heating...you must hit the fire button over again..a 10 second heating

a 10 second heating cycle isnt long enough to get the gentle [quality cleaner vapor]...of the slow heating effect of a 1 to 2 minute heating cycle .... like the way .....volcano or plenty ....desk top vapes work...

FAST VAPORIZATION and less temperature control...!.... is the trademark of most lower priced mods using EMESH or E juice.....it vapes the molecule by its self.. in just under 2 seconds!... and can send one on a far out journey into hyperspace...

...but often burns some of the molecule in the process causing some throat iratation ... waste of product.... and not so nice taste... and recall of the experiance is fuzzy...asking yourself .........
what the hell just happened??

adding.... rue ..or passion flower... to the molecule slows down the experiance enough that you can navigate better while emersed..and remember more at come down...



psychedelic citrate......just waiting to be used in a new way!
 

Attachments

  • DSC01678.JPG
    DSC01678.JPG
    741.3 KB · Views: 4
Last edited:
I think the secret to better vaporization is .....slower aplication of the right temperature ....like the ...plenty...took...1 to 2 minutes as it heated up at a slower genteler pace

...reducing the chance of burning the material...and causing a good compleate vaporization of product...and high quality vapor...

most hand held vapes alow a ...10 second heating cycle.... then the mod shuts off to prevent overheating ..then to continue heating...you must hit the fire button over again..a 10 second heating

a 10 second heating cycle isnt long enough to get the gentle [quality cleaner vapor]...of the slow heating effect of a 1 to 2 minute heating cycle .... like the way .....volcano or plenty ....desk top vapes work...

FAST VAPORIZATION and less temperature control...!.... is the trademark of most lower priced mods using EMESH or E juice.....it vapes the molecule by its self.. in just under 2 seconds!... and can send one on a far out journey into hyperspace...

...but often burns some of the molecule in the process causing some throat iratation ... waste of product.... and not so nice taste... and recall of the experiance is fuzzy...asking yourself .........
what the hell just happened??

adding.... rue ..or passion flower... to the molecule slows down the experiance enough that you can navigate better while emersed..and remember more at come down...



psychedelic citrate......just waiting to be used in a new way!
TURNING CITRATE BACK INTO CLEAN FREEBASE....small scale test...
after putting a very tiny amount of D/citrate powder ...[in picture in post above]... into small glass tube.. ...only covered the bottom of tube... [re.desolved in distilled water]...
I ..then based water with a pinch or two of lye ..then added a clear 2/3rd of an inch layer of fresh napatha ... shook the test tube ....let seperate and took three pulls... then put tiny amount of napatha in freezer in tiny bottle...just trying to get idea of the density of the molecule....per 1ml of napatha...used.......probibly made a 25 to 30 mg dose of very clean looking freebase crystals...this was an easy transformation of D citrate... back into quite pure looking freebase crystals...
.pictures below..
 

Attachments

  • DSC01680.JPG
    DSC01680.JPG
    456.7 KB · Views: 4
  • DSC01681.JPG
    DSC01681.JPG
    376.1 KB · Views: 4
  • DSC01684.JPG
    DSC01684.JPG
    501.5 KB · Views: 4
  • DSC01685.JPG
    DSC01685.JPG
    420 KB · Views: 4
  • DSC01687.JPG
    DSC01687.JPG
    458.5 KB · Views: 4
  • DSC01688.JPG
    DSC01688.JPG
    502.6 KB · Views: 4
Last edited:
TURNING CITRATE BACK INTO CLEAN FREEBASE....small scale test...
after putting a very tiny amount of D/citrate powder ...[in picture in post above]... into small glass tube.. ...only covered the bottom of tube... [re.desolved in distilled water]...
I ..then based water with a pinch or two of lye ..then added a clear 2/3rd of an inch layer of fresh napatha ... shook the test tube ....let seperate and took three pulls... then put tiny amount of napatha in freezer in tiny bottle...just trying to get idea of the density of the molecule....per 1ml of napatha...used.......probibly made a 25 to 30 mg dose of very clean looking freebase crystals...this was an easy transformation of D citrate... back into quite pure looking freebase crystals...
.pictures below..
Very white crystals! .... from the conversion back to freebase! zoom pictures...
 

Attachments

  • DSC01690.JPG
    DSC01690.JPG
    685.4 KB · Views: 1
  • DSC01696.JPG
    DSC01696.JPG
    858.4 KB · Views: 1
  • DSC01697.JPG
    DSC01697.JPG
    728.8 KB · Views: 1
Back
Top Bottom