I have made a machine out of a mini corona bottle that I found. The way I load it is I set it upright on a table and put spice on top of the wool. I then heat the neck of the bottle so that the spice sticks to the wool (really a stainless steel scouring pad). I then flip it upsidedown to vape it. This is the part I am confused about as I have read so many different ways about how to apply the heat. Here are some of the ways.
1. Just heat the neck of the bottle with a pocket jet lighter - (I find that this does not apply enough heat to vaporize it, or it takes too long due to the thick glass in the neck of the bottle.)
2. Use a bic lighter about an inch from the base - (I find this difficult because as one inhales it draws the flame closer thus making it hotter and you have to move it away, this gets tough the deeper you go)
3. Use the pocket jet lighter under it so as not to touch the steel wool but direct the heat to it - (this has been the best way so far, my concerns are that it might get too hot and i am burning it and dont realize it. It is tough to find the sweet spot but when you do it is good. I had good success in swiping the flame past the bottom back and forth and it gives short bursts of smoke)
Which of these ways are correct or is it something else? Also can you tell the difference between vaporizing it properly or if you are burning it. I remember my last voyage I got such a big plume of smoke (or vapor) that it made me cough it out and I got scared that I lit the stainless steel scouring pad on fire and I breathed in fumes, though I know I didn't because I preheated it to be red hot to get the stuff off of it from manufacturing and also it wasn't on the heat nearly enough. Obviously you aren't thinking the best as this is taking place but I was just curious on how to apply the heat during this stage as I have read so many different things or it is too vague. I am having trouble getting the full 50mg, I think it might take some time before I can get this down.
1. Just heat the neck of the bottle with a pocket jet lighter - (I find that this does not apply enough heat to vaporize it, or it takes too long due to the thick glass in the neck of the bottle.)
2. Use a bic lighter about an inch from the base - (I find this difficult because as one inhales it draws the flame closer thus making it hotter and you have to move it away, this gets tough the deeper you go)
3. Use the pocket jet lighter under it so as not to touch the steel wool but direct the heat to it - (this has been the best way so far, my concerns are that it might get too hot and i am burning it and dont realize it. It is tough to find the sweet spot but when you do it is good. I had good success in swiping the flame past the bottom back and forth and it gives short bursts of smoke)
Which of these ways are correct or is it something else? Also can you tell the difference between vaporizing it properly or if you are burning it. I remember my last voyage I got such a big plume of smoke (or vapor) that it made me cough it out and I got scared that I lit the stainless steel scouring pad on fire and I breathed in fumes, though I know I didn't because I preheated it to be red hot to get the stuff off of it from manufacturing and also it wasn't on the heat nearly enough. Obviously you aren't thinking the best as this is taking place but I was just curious on how to apply the heat during this stage as I have read so many different things or it is too vague. I am having trouble getting the full 50mg, I think it might take some time before I can get this down.


Plus it refers to one (or two?) of my most favorite songs at the same time! And I guess I'm a fan of bowls as well. :lol: