-
Members of the previous forum can retrieve their temporary password here, (login and check your PM).
Youtube tek
- Thread starter an3x1er
- Start date
Deaths Angel
Rising Star
- Merits
- 42
Imho u shouldn't really have to follow a tek. Before you attempt an extraction you should make sure you understand the reason for every step. It's really not that hard and patience is a virtue.
These are the steps for a basic a/b extraction
First you have to get the dmt out of the mimosa. This goes quicker in a warm acidic enviroment. So if for example you wanted to extract 100 grams i would boil them 3 times for 2-4 hours in 2 liter water and 1 liter vinegar (these are large amounts of water because i like to make sure i get everything) . Then you filter and combine all the (normally reddish) water and reduce the 9 liters down to 1 liter.
DMT naturally occurs as a salt. However, as a salt it will not disolve in your apolar solvent (naptha) so we need to convert it to a freebase (free - base) molecule. Only thing we have to is adjust our ph. it should be close to 12. this can easily be done by using sodium hydroxide or any other base like sodium bicarbonate (thats a weak base tough).
After adding enough base, the dmt will easily disolve in a apolar solvent. This is your naptha/limone/most other pure apolar hydrocarbons are ok. add 1/3 solvent to your total volume of water, and shake it gently for 10-15 minutes then seperate the upper layer from the bottom. Again do this 3 times and combine your solvents, then you let it evap with a fan at room temperate untill you see little white crystals forming. Then put it in the freezer overnight, quickly take it out and pour of your solvent, the crystals will remain and then you airdry the remaining solvent
If you used enough base this method should have 100% succes rate. if you have any questions i'll do my best to answer them
Good luck with your hyperspace travels.
These are the steps for a basic a/b extraction
First you have to get the dmt out of the mimosa. This goes quicker in a warm acidic enviroment. So if for example you wanted to extract 100 grams i would boil them 3 times for 2-4 hours in 2 liter water and 1 liter vinegar (these are large amounts of water because i like to make sure i get everything) . Then you filter and combine all the (normally reddish) water and reduce the 9 liters down to 1 liter.
DMT naturally occurs as a salt. However, as a salt it will not disolve in your apolar solvent (naptha) so we need to convert it to a freebase (free - base) molecule. Only thing we have to is adjust our ph. it should be close to 12. this can easily be done by using sodium hydroxide or any other base like sodium bicarbonate (thats a weak base tough).
After adding enough base, the dmt will easily disolve in a apolar solvent. This is your naptha/limone/most other pure apolar hydrocarbons are ok. add 1/3 solvent to your total volume of water, and shake it gently for 10-15 minutes then seperate the upper layer from the bottom. Again do this 3 times and combine your solvents, then you let it evap with a fan at room temperate untill you see little white crystals forming. Then put it in the freezer overnight, quickly take it out and pour of your solvent, the crystals will remain and then you airdry the remaining solvent
If you used enough base this method should have 100% succes rate. if you have any questions i'll do my best to answer them
Good luck with your hyperspace travels.
- Merits
- 42
Earthwalker
Rising Star
- Merits
- 42
:shock:deathsanus said:
:shock:deathsanus said:
These amounts are over the top IMHO esp the naphtha , also IMHO I use Cybs salt TEK all the time , it's super easy , quick , clean efficient , and high yeilding , also has pics for greater understanding ! :thumb_up:
Earthwalker
Rising Star
- Merits
- 42
Lev8177 said:
Do not listen to this muppet :!: , " the brown stuff is dust " but " the brown stuff is good dmt "
What a total clown ! IMO stay away , far away from this dude omg lol:lol:
Earthwalker
Rising Star
- Merits
- 42
woody said:
I no that stb yeilds less especially when using acacia bark , but the salt after the adidifying stage helps push out the dmt within the first six or so pulls ! The advantage of the max-ion TEK which is the same as the salt TEK except for the freeze thaw x 3 and a longer acid soak , it helps lyse the walls of the cells to help break them down !
I think that's correct !
sigh... Youtube tek?! seriously?? That's a good way to enlighten the masses on the wonders of DMT... I hate seeing things like this on youtube.
He could have at least done it properly lol
Lev... Come on man. I've known you for like 20 minutes and I can't count the rules you've broken. I don't suppose this youtube tek is against the rules, but... sigh.
He could have at least done it properly lol
Lev... Come on man. I've known you for like 20 minutes and I can't count the rules you've broken. I don't suppose this youtube tek is against the rules, but... sigh.
Earthwalker
Rising Star
- Merits
- 42
Come of the grass lev8177 ,, why on earth would you think we can just break rules and it'll be ok ,,
Truely you're not showing any effort into researching and studying any of the TEKs YouTube doesn't count , and if you were to follow that goose you're sure to fail !
I'll give you advice that is of most importance to you , Research is key !
I also see your've made 4 posts , you're 1st post should've been an introduction of you'reself so we get a feal for the person you are , but all you've done is asked to be spoon feed ,
Truely you're not showing any effort into researching and studying any of the TEKs YouTube doesn't count , and if you were to follow that goose you're sure to fail !
I'll give you advice that is of most importance to you , Research is key !
I also see your've made 4 posts , you're 1st post should've been an introduction of you'reself so we get a feal for the person you are , but all you've done is asked to be spoon feed ,
akiraxhoshizora
Rising Star
- Merits
- 42
lol youtube the only good teks on there is for mushrooms and san pedro tea
darklordsson
Rising Star
- Merits
- 42
Yeah, I don't trust much things off of youtube. Its being blatantly lied to or told inadequate info by the one that posted it...
Research is good to do friend. Plus you come across some cool stuff you never even knew about as well sometimes!
Namaste,
---dls---
Research is good to do friend. Plus you come across some cool stuff you never even knew about as well sometimes!
Namaste,
---dls---
Ugh, I just watched the video. It is dangerous and the comments are full of confusion and misinformation.
Please — at least wear gloves and eye protection, keep some vinegar close and easily accessible to neutralise spills.
As said before, YouTube is not the place to get advice on things like this. We have an incredible resource here — so much knowledge, a better class of contributors, clued-up people to save people from themselves. Why go anywhere else?
Please — at least wear gloves and eye protection, keep some vinegar close and easily accessible to neutralise spills.
As said before, YouTube is not the place to get advice on things like this. We have an incredible resource here — so much knowledge, a better class of contributors, clued-up people to save people from themselves. Why go anywhere else?
- Merits
- 42
Simply showing someone the errors of their ways is enough, no need to put someone down for not having done the research or read the forum rules.
I read a few teks many many times before i chose the right one for me. First things first, which extraction chemicals are accessible to you, then go from there.
I read a few teks many many times before i chose the right one for me. First things first, which extraction chemicals are accessible to you, then go from there.
Indeed, and it shows intelligence asking this question:anrchy said:
I am sure most who see that tek on YouTube won’t bother searching for further advice after.Lev8177 said:
While it is good to educate it is not good to scare new members of our community off when asking perfectly good questions! Everyone deserves a chance.
- Merits
- 42
Firstly, read through the FAQ, familiarize yourself with the basic chem terminology, even use the google wiki to learn basic terms if need be, then go from there.
Even go to google, type in a set of keywords or your question, then type 'dmt nexus' after that and most if not all your answers will come up. It works really well ime.
Cybs tek is great, so is nomans stb tek, etc. Just take your time, learn the terminology, research throughout the forum thoroughly. This can take weeks, or even months, before your actually able to nail a tek down, get the materials necessary, etc - it's a journey in and of itself. Read, read , read. Ime, reading and learning step by step and not being in a rush will pay off in the long run.
Even go to google, type in a set of keywords or your question, then type 'dmt nexus' after that and most if not all your answers will come up. It works really well ime.
Cybs tek is great, so is nomans stb tek, etc. Just take your time, learn the terminology, research throughout the forum thoroughly. This can take weeks, or even months, before your actually able to nail a tek down, get the materials necessary, etc - it's a journey in and of itself. Read, read , read. Ime, reading and learning step by step and not being in a rush will pay off in the long run.
