ZSTAT AREO CHAMBER...used with the molecule?

[1Starway7]

[[[[Could this be a safer less wastfull way to vape?....]]],,I will find a way to connect the AREO Chamber to my plenty vape...Im impressed at the claim... it keeps the vapor in the chamber longer !.... and anti static material ... this valved unit prevents the material from sticking to the walls of the chamber.... ..that may? .... keep the cloud of vapor floating longer ....after taking a hit....the remaining vapor is trapped inside the tube....]NO WASTE! . the taste may? even be preserved loger.. this sanitary medical unit .. was made for asthma symptom releaf ...will try to aply it to DMT vapor use... if used right this inhalation tube could be a one hit breakthrough device? ....... only one difference..the asthma medicine... [this tube was intended for].... is in a presurized container that sprays into the chamber and is held in the valved chamber ...and vaporized dmt requires heating to make a vapor.... this idea may work fine.... or may not...will take a test...

AI Overview



The AeroChamber Plus Z STAT Anti-Static Valved Holding Chamber uses a special anti-static polymer to neutralize static charges. This keeps the vapor/aerosol suspended in the chamber longer.
National Allergy
The combination of anti-static material and valve technology suspends the medication longer through two main mechanisms:

• Preventing Static Cling: Standard plastic chambers build up an electrostatic charge that causes medication particles to stick to the walls. The anti-static properties of the AeroChamber Plus Z STAT Chamber eliminate this charge, allowing the vapor to float freely in the air.
  National Allergy +2
• The One-Way Valve System: Once the medicine is puffed into the chamber, the valved holding chamber mechanism traps the cloud and prevents it from escaping. Because of this, the medication is suspended inside, giving you time to breathe it in at your own pace without needing perfect coordination.

photo 1891 shows free flow mouthpeice,,, about 1 1/2 inch behind the mouthpeice

is the valve that holds in the vapor...and quickly opens when taking a hit...

1890 is rubber recepticle where the buterol can was connected...so i must connect the vape pipe to this end​

 

[Flufferus]

lol i used to use these for asmtha as a kid

personally not quite a big enough chamber for me and cannabis, but may work for dmt hits? still think its alil small

 

[1Starway7]

lol i used to use these for asmtha as a kid

personally not quite a big enough chamber for me and cannabis, but may work for dmt hits? still think its alil small

vapor can compress! plus its anti static vapor should remain in vapor form in it without sticking to the walls of the tube...... for extended time..

 

[1Starway7]

im starting to fit this convection vape together.... im comming out of plenty vape with ...copper tubing...going into bubbler with vinal tubing....[far enough away from heat]... vinal far enough away ..it wont melt .... [its only dark in picture because [in past]...i heated it ....trying to bend it.... will replace with new tubbing...
after going through bubbler... cooled vapor will enter the ... Areo Chamber tube... and vapor will be locked in the tube by a valve... and will leave the tube only when taking a hit of any size you choose ..leaving left over vapor still floating in the tube hopefully not condensing in the anti static walls of tube ..[for atleast a longer than normal time compaired to other pipes...the exiting mouthpeice is huge alowing for a compleat hit... if desired...[check photos above]
the AREO CHAMBER can be quickly pulled away from the stem..[keeping finger over inlet hole ] preventing vapor from escaping...
this pipe may be safer in some ways ....vapor leaves the pipe through copper tubing absorbing most of the heat as to not melt the tubing........using convection...using a bubbler to trap unwanted air born particles...and cool vapor]...and the AREO CHAMBER is medicly sanitary and can be taken apart and cleaned easily...

if i can find something safer than vinal tubing to link some of the sections together ill use it later...anyway .....by the time the vapor goes through the distilled water it will be too cool melt anything....should be safe to inhale..

If one chooses..they can easily remove the bubbler and vape...but the vapor may. be a little warm but should cool inside the chamber...

 

[Flufferus]

nice man i think it will work decent for dmt hits

 

[1Starway7]

nice man i think it will work decent for dmt hits

yes the... AREO CHAMBER ....is origionally designed to deliver deeply ..a full lung full of medicine to help asthma sufferers...My hope is that it will work .. in the same way with molecule vapor..

also.... when you combine the high quality ... convection vapor.....that the... plenty vape ....should produce... [[less dose.]]...should be more in effect!.......

if the ZSTAT function works with molecule vapor... in holding the vapor in ....floating form.... inside the chamber longer...this gives one the convienience ...of slowly taking puffs of vapor in a more cautious manor...... .[i read the intended asthma medicine vapor stays active in chamber for up to 10 full seconds].......not shure yet how long the

molecule vapor will remain in vapor form in side chamber ?

Or for the... [braver Pilots ].....if they choose....they can pull the whole load out of the chamber......that might??......end up in a ..... clean one hit breakthrough!.... because of the purity of the vapor...

NOTE....the built in valve closes up after taking hit ...[trapping in the left over vapor] preventing waste....

Im not shure that i will have that kind of nerve pulling in the whole hit of high purity vapor.....untill i first tested lower doses ... ...i would start low on the hits ..... because high purity vapor can surprisingly potent!

removing the bubbler may make the hit even stronger....!

for health reasons....im aiming for keeping the dose.... pure and clean as posible....

i guess this whole idea could be applyed to a small portable vape...with some imagenation....

 

[Flufferus]

the water just removes some vapor, but vastly cools it down. only trade off with it. not much to clean there., but if any is burnt it would likely trap those impurities. nice setup!

 

[1Starway7]

the water just removes some vapor, but vastly cools it down. only trade off with it. not much to clean there., but if any is burnt it would likely trap those impurities. nice setup!

Plenty vape like the volcano... has never burnt any material .... its a medicly aproved.. convection desk top vape!