ArchetypalDreamer
Rising Star
Hi all,
Some of you may be aware that I had my first experience with Aya very recently (Warm Greetings from the UK - Introduction Essay - Welcome to the DMT-Nexus) but it certainly wasn't the most successful
Following an awesome guide on this very forum, I used an old cotton shirt to filter the x3 brews I made, covering a pan with the shirt and pouring the liquids through it. After this process, the liquid seemed to be clear.
Reducing it down produced some sediment however... and stuff that actually looked like bark :shock:
Consequently, my reduced down brew was full of bits; is this normal, or was extra filtration required?
Thanks in advance
Some of you may be aware that I had my first experience with Aya very recently (Warm Greetings from the UK - Introduction Essay - Welcome to the DMT-Nexus) but it certainly wasn't the most successful
Following an awesome guide on this very forum, I used an old cotton shirt to filter the x3 brews I made, covering a pan with the shirt and pouring the liquids through it. After this process, the liquid seemed to be clear.
Reducing it down produced some sediment however... and stuff that actually looked like bark :shock:
Consequently, my reduced down brew was full of bits; is this normal, or was extra filtration required?
Thanks in advance



