• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

Don't have big jar for Cybs tek. Ways to alter the method?

Migrated topic.

Squirrel

DMT - Not yet
Joined
Sep 7, 2013
Messages
88
Merits
42
Hi there,

So I am ready to do Cybs atb extraction any day now. However you need a 1 liter jar but I only have one that will hold about 600 ml. I asked Cyb and he said to use just a little less of everything and make sure that there is 50 ml of solvent at the top. And yesterday at the chat I forgot who but a member told me that he had only a 600ml jar and was doing 2 washes in a slow cooker and then added 400 ml to a jar.

I only have 50g of mimosa and don't want to mess this up, does anyone have any good ideas for what I should do, and if you don't mind writing the instruction with some detail.

Thanks :)
 
Cyb wrote the tek, I highly doubt he would steer you in the wrong direction. My advice? Follow Cyb's advice. 😁

Glad to see you back on the forum again, Squirrel! :thumb_up:
 
Easy !! You're only doing 50g bark so you only need a 750ml bottle but just don't top off with the 140ml after basing

Acidify 260ml. or use hcl ph 2-4 200ml then
Salt. 100ml. ~~~~~~~~~~~~~~ salt. 100ml
Base 200ml. ~~~.Lye/ base.ph 12-14 200ml
= 500ml. ~~~~~~~~~~~~~~~~ = 500ml total solution

Leaves 30-40ml for solvent ! That should be fine aslong as it's not to thick ! Remember you can customize to you're needs aslong as the princables of chemistry stay the same ,, it'll work !!!
 
And as we all know : make sure you wear gloves and goggles when mixing in the heated NPS, especially when your jar is pretty full near the lid. It's pretty easy for soup to spit out the top if you're not gentle until temperature equilibrium occurs between the two ingredients

Take care
 
Earthwalker said:
Easy !! You're only doing 50g bark so you only need a 750ml bottle but just don't top off with the 140ml after basing

Acidify 260ml. or use hcl ph 2-4 200ml then
Salt. 100ml. ~~~~~~~~~~~~~~ salt. 100ml
Base 200ml. ~~~.Lye/ base.ph 12-14 200ml
= 500ml. ~~~~~~~~~~~~~~~~ = 500ml total solution

Leaves 30-40ml for solvent ! That should be fine aslong as it's not to thick ! Remember you can customize to you're needs aslong as the princables of chemistry stay the same ,, it'll work !!!
Alright thanks a lot everyone! I know that Cyb wrote and I should follow his advice, I just didn't know the amounts that should be used
 
Entheogenerator said:
Glad to see you back on the forum again, Squirrel! :thumb_up:
glad to here from you too :) I am sure I will be on the site more often after this extraction.
 
Back
Top Bottom