• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

Greetings and questions, oh no! Please help :)

Migrated topic.

Lucidity

Rising Star
Joined
Jun 7, 2014
Messages
7
Merits
42
Hello friends first post, long time lurker. :d

Now I'm not sure if this is were to post this problem as I'm not sure we're else I can post, :surprised but maybe some one can help me out!

I have seemed to of emulsified my last batch (doubled my ingredients in my last batch and it no longer fit in the jars I used so I poured It I to a larger glass vessel and it seems like there is no longer any naptha floating on top :thumb_dow I fear it's suspended in the bark/lye and I remember seeing some were how to fix this with lye and I don't remember or want to mess up this batch any further as it's larger than what I'm use to...

I also can't fine the search engine...
Edit : nvm... Found it sorry
Sorry I'm so new guys thanks for barring with me ;);)
 
After I've looked arround I'm not sure I'm dealing with emulsion I was stirring 100 ml of naptha in 100g of lye in 500 ml of water with 100 g of mhrb in a very large measuring cup in hot water, when I transferred it carefully into a large mason jar it appeared as there was no longer naptha in the jar I let it sit all night no more separation....just a tiny layer of naptha

:thumb_dow What the hack did I do....
 
Killer, thank you!

So it's not emulsified?!

I don't mean to be a parrot but just throw in 80g of salt, warm it up and add 200 ml of water?

Not extra naptha or lye?!
 
Thanks again for being so quick your a life saver :thumb_up:

That is the tech I've been following;

Between step 9 and 10 I poured it off into a new container to pull it and the naptha dissipated! Granted I sikipped on step 6and 7...
 
Lucidity said:
So it's not emulsified?!

You'll know if it's an emulsion because it will look like a layer of tiny bubbles between the base mix and the solvent.

I don't mean to be a parrot but just throw in 80g of salt, warm it up and add 200 ml of water?
Not extra naptha or lye?!
Add 500ml of water to the jar...so it's more watery. (around 900ml or litre total) leave enough room for your solvent.
Add salt (if you havnt already) as it will help with the extraction (and emulsions)
 
Lucidity said:
..just throw in 80g of salt, warm it up and add 200 ml of water?
It is more practical to saturate 200 ml of water with salt and then add that. Just boil the 200 ml with an excess of salt until no more dissolves (compensate for water lost to boiling off), let the brine cool down a bit and then add it.
 
So I threw in 500 ml of water and 80g of salt, warmed it upwaited a few hours verry little naptha was there so I threw in 100 ml stirred 4 times and went to pull and the naptha came out Amber/reddish :surprised so i :!: and figured to post befor I went ahead and crystallized....

What should I do?
The olny thing I can think of is to freeze precipitate see what happens and clean it up with naptha or another solvent?
Hopefully some one has a trick up there sleeve.

pre-thank you!

I can attach pictures if I can figure it out.


64691D84-B1BC-4D06-A281-87AA915DD306-425-000000BA9F499CC6_zps771767f4.jpg
 
Back
Top Bottom