I used the Cybs Salt method with MHRB and followed the measurements correctly as they are there, I just used Zippo lighter fluid instead of naphtha, I used vinegar, salt and hot baths. After removing it from the condenser, it gave me a low amount, not to mention no crystals. I tried it once more and this time it gave me 60mg and for the third time today it gave me around 60mg again. I believe this is an extremely low amount considering the results of the tek. I would like to understand why my solvent is pulling little dmt with each pull? Is there anything I can do to pull more dmt in one pull? I am new to this world and this is my first extraction.
-
Members of the previous forum can retrieve their temporary password here, (login and check your PM).
HELP Problem with Solvent and Pulls. Cybs' Hybrid ATB 'Salt' Tek
- Thread starter guialvxsz
- Start date
i would suggest trying with naphtha instead zippo fluid evaporates WAY faster giving your crystals less time to form (i am wrong) you have other options for solvents too such as xylene and D-Limonene aswell tho which can give full spectrum pulls
Last edited:
That doesn't have any impact in the yield, which was OP's main issue (a year and a half ago).
You weren't wrong in that with faster evaporation crystals have less time to form, and thus there will be smaller crystals or even no crystals (e.g. a waxy layer). But the amount of DMT will be the same.
