Tryptallmine
Rising Star
Decided to start a thread due to invading someone else.
Issues: dmt lost? suspended in a solution.
A little perplexed with this one. A friend watched a couple of 100g extractions out of interest. The first yielded 2.24g which was the best yield ever observed. The pulls were very very saturated. However it had a little bit of base in it after 24 hours in the freezer so It got re dissolved in fresh naphtha. It should have just been re-xed from that point, but It was decided to include it in the mini a/b of the second extraction.
The second extraction was with the same amount of material (ACRB), again pulled highly saturated NPS from the aqueous solution in line with the first extraction. There should have been a combined total of around 3-4g between the two.
It was decided that a mini a/b would be a good idea to get super clean spice. The acidified solution (HCl - 500ml De-ionized water) was mixed in with the dmt saturated naphtha from the first extraction and second extraction - around 400ml nps total. Mixed gently, it looked nice in the sense that it had separated a lot of plant fats out and left a dirty layer. The NPS was decanted and saved in a flask in the event that something were to go wrong. The solution was then re based.
It went a very cloudy white and there were pretty large crystals forming between the aqueous and NPS layers. Approximate 50-60mg chunks of what looked to be pure white spice.
4 pulls were taken off the mini A/B expecting the pulls to be very cloudy and saturation however they pulled clear with the exception of the first. The first pull was 'ok' and it just about crystallized entirely without putting it in the freezer. However looks to be about 500mg or less. Super fine crystals forming in scratches of the glass surface.
The naphtha didn't seem to want to take up any of the DMT from the solution. So there is at least 2-3 grams of dmt 'somewhere'. A second look at the plant fat solvent from the cleanup smells more like dmt than solvent. Nothing was discarded on the basis that it's probably in the A/B cleanup?
What would theoretically be the best way to go about resolving this?
Combine everything back (current vessel + cleanup vessel) into a 2lt vessel, acidify it 2-3ph, add NaCl then basify out to 12ph and try and pull again with clean solvent? The soup at the moment apparently looks like a snow globe. Clear, milky liquid with lots of fine white specs throughout. The A/B solution looks dirty with a little bit of aqueous on the bottom, maybe its in there? around 30ml.
Issues: dmt lost? suspended in a solution.
A little perplexed with this one. A friend watched a couple of 100g extractions out of interest. The first yielded 2.24g which was the best yield ever observed. The pulls were very very saturated. However it had a little bit of base in it after 24 hours in the freezer so It got re dissolved in fresh naphtha. It should have just been re-xed from that point, but It was decided to include it in the mini a/b of the second extraction.
The second extraction was with the same amount of material (ACRB), again pulled highly saturated NPS from the aqueous solution in line with the first extraction. There should have been a combined total of around 3-4g between the two.
It was decided that a mini a/b would be a good idea to get super clean spice. The acidified solution (HCl - 500ml De-ionized water) was mixed in with the dmt saturated naphtha from the first extraction and second extraction - around 400ml nps total. Mixed gently, it looked nice in the sense that it had separated a lot of plant fats out and left a dirty layer. The NPS was decanted and saved in a flask in the event that something were to go wrong. The solution was then re based.
It went a very cloudy white and there were pretty large crystals forming between the aqueous and NPS layers. Approximate 50-60mg chunks of what looked to be pure white spice.
4 pulls were taken off the mini A/B expecting the pulls to be very cloudy and saturation however they pulled clear with the exception of the first. The first pull was 'ok' and it just about crystallized entirely without putting it in the freezer. However looks to be about 500mg or less. Super fine crystals forming in scratches of the glass surface.
The naphtha didn't seem to want to take up any of the DMT from the solution. So there is at least 2-3 grams of dmt 'somewhere'. A second look at the plant fat solvent from the cleanup smells more like dmt than solvent. Nothing was discarded on the basis that it's probably in the A/B cleanup?
What would theoretically be the best way to go about resolving this?
Combine everything back (current vessel + cleanup vessel) into a 2lt vessel, acidify it 2-3ph, add NaCl then basify out to 12ph and try and pull again with clean solvent? The soup at the moment apparently looks like a snow globe. Clear, milky liquid with lots of fine white specs throughout. The A/B solution looks dirty with a little bit of aqueous on the bottom, maybe its in there? around 30ml.