• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

Melting Spice instead of solvent for enhanced leaf

Migrated topic.

trancenut

Rising Star
Joined
Nov 25, 2009
Messages
33
Merits
42
That SWIM has been fairly active with ayahauasca, insuffling (not likely again) and has been looking at ways to start smoking.

He had no solvent like acetone and suddenly thought "Why not melt the spice - gently - and let the desired material absorb the spice without smelly solvents?"

So he did. And it worked, albeit crudely, as there were no exact measurements taken. After the material, in this case pau d'arco, had absorbed the spice, there was some residue of spice left over, but there was also a good amount absorbed. Any spice residue was left to be mixed with SWIM's next naptha ext. so very little if any will be completely lost.

Either a water bath or some kind of electric hotplate with a low setting that melts without boiling would be the best options, it doesn't take too long, so constant supervision (always recommended) is no hassle. Oh yes - and only carried out where this process is legal, of course.

SWIM is tentatively upping the smoking dose little by little to get to know the effects of smoking before he goes for "breakthrough". Seems quite good judging by the smiles :d

Don't know if anyone else has tried or used this method, but there it is anyway!!!

All good things,

trancenut.
 
Hey there bro, good to hear that it worked for you, but, I wonder weather the herb was just coated by spice rather than being absorbed into the herb?

Also, you should be able you use the naptha to infuse the herb, and you can pick up household acetone from your local chemist or boots.
 
Hi there, Gammagore and cheers for your feedback.

I have asked SWIM and he tells me that the pau d'arco was definitely absorbing rather than coating. As long as the material for absorbing is at a temperature above melting point of the dmt then it should flow into the tiny nooks and crannies very nicely! I would think that pau d'arco worked well as it is powdered bark and would have some porous nature to it. Other material may act differently, presumably if the cellulose wall on leaves has not been broken down, for example, although I could be wrong about that.

It was something SWIM tried as he was without some solvents and didn't fancy using naptha.

Thanks for the comments.

trancenut
 
Back
Top Bottom