• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

need help with stb extraction

Migrated topic.
Sort by date Sort by votes
This is exactly what I did for my first extraction, except I took it even farther and used a full pound of bark (~454 grams, I never actually measured it) with a pound of NaOH. I tried doing the whole thing in one 80oz glass jar with ~2000cc's water, but it ended up being way too thick so I had to separate it into 2 80oz jars with +2000cc's water each. I also had a wicked emulsion that formed on it, but I simply sucked the emulsion layer out into a separate jar and added sea salt+lye+water and the emulsion disappeared. I ended up doing 5 pulls on each jar with about 200ml of naphtha for each pull. The individual naphtha pulls from each jar were combined then evaporated. I just kept doing pulls until the yield significantly dropped (pulls 1-4 yielded above 1 gram each time, pull 5 was ~500mg). I ended up yielding ~7.05 grams of barely yellow DMT.

Smaller batches do have their conveniences over big ones, and big batches have some convenience over small ones, I think its just personal choice. Someone feel free to correct me if I got anything wrong, or if you have better advice.

Good luck cosmic butterfly (love the name BTW)

Peace, and Love.
 
Upvote 0 Downvote
Hey for STB a common method for determining how much of each part to use is this:

15ml of water and 1 gram lye per 1 gram of MHRB used. then 2ml solvent to 1 gram of bark divided by 4 separate pulls.

Please write an introduction essay before posting other topics.
 
Upvote 0 Downvote
Back
Top Bottom