• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

NPS and the soup, timing of pulls.

Migrated topic.
murklan

murklan

Established member
I have a small question that I've not found an answer to. Perhaps I've not looked enough, or I could have done a test. But anyway, someone here probably knows.

Then doing the pulls from the based soup (heated or not) the NPS separates really fast for me. I turn the flask for some minutes and then let rest, and repeat.
My question is regarding the DMT and if it is 'stable' in the NPS or if it might go back to the soup if I let it stand for a while before sucking it up and put in freezer?
I usually let the NPS it stand for a day in the soup but always mix it a few times before taking it out from the soup. Is it better to do it directly after separation or does it not matter?
I usually do a variant of MAX Ion tek.

Thanks!
 
DMT freebase is *much* more soluble in NPS than the base soup, in fact it is hardly soluble in aqueous solution at all. You need have no worries about it "going back" into the base once it has dissolved in the NPS.

Once the NPS has separated then the only bit in contact with the soup (that still might contain suspended DMT freebase precipitate ) is the bottom of the layer. So not much DMT freebase is going to dissolve into the NPS from there. The only thing extended standing time might do is allow a bit more NPS to separate from the soup, so it's wasted time on anything but your last pull, IMHO, but won't do any harm.

Have fun!
 
On a cold night, you might find dmt crystals already crashed out of the NPS on top of the base soup. In that case reheat the container until the crystals redisolve and pull
 
Great! Thanks!

I thought it was like that but I wanted to be sure. I've also thought about a heated soup and if it matters if you cool it down before sucking up the NPS?

Fun? Yes, dealing with pH >13 liquids and volatile petroleum in the kitchen is my kind of fun! :)
 
Sakkadelic said:
On a cold night, you might find dmt crystals already crashed out of the NPS on top of the base soup. In that case reheat the container until the crystals redisolve and pull
Click to expand...

Ok, never thought about that. Thanks.
But in my NPS I've only once seen it cloudy before freezing. So I guess it's not really saturated.
 
I think only the yuck yellow polymer thing precipitates back at room temperature and not the true dmt. Only if it was supersaturated which is impossible during a regular extraction. So i think chance is 0 and even if it would precipitate it would not go back into the water and instead stay as clouds in your soup. One member claimed it would even slowly form Solid dmt at the bottom so even this would be no problem.
 
Sakkadelic said:
murklan said:
Sakkadelic said:
On a cold night, you might find dmt crystals already crashed out of the NPS on top of the base soup. In that case reheat the container until the crystals redisolve and pull
Click to expand...

Ok, never thought about that. Thanks.
But in my NPS I've only once seen it cloudy before freezing. So I guess it's not really saturated.
Click to expand...

here I found the picture, just some xtals - Advanced/Enhanced chemistry - Welcome to the DMT-Nexus
Click to expand...

Wow, never seen anything like it. Perhaps I should do a more slow cooling down instead of putting it directly in -18 C. On the other hand, I quite pleased with the angels dandruff as it is.
 
Back
Top Bottom