50g of acacia confusa bark
50g of caustic soda
50g of salt- non-ionized
50ml white distilled vinegar
~500ml distilled water
Place ground bark into your first mason jar, add about 200ml of water and go ahead and add 50-60ml of vinegar (trying to achieve a PH of 2) Place this mixture in a “warm” water bath for one hour, gently stirring.
While waiting on the hour to pass, go ahead and dissolve 50g of salt into a bit of water. The only point of this is so that you will not have to try to dissolve inside of the jar we are trying not to agitate to much.
After you have your dissolved salt, go ahead and slowly add it to the jar. Gently shake/swirl. Try not to make bubbles.
Next step is to add your lye(shooting for PH of 12 or higher). 50g of lye, add it to the water, not the other way around.
Then you are ready to add your organic solvent. Naptha is my choice, so slowly add about 50ml of that. Same shake/swirl method while in a warm bath. Repeat as needed ~4 runs then test the fifth by freezing it.
And upon doing this I should result in pure white crystal? Or am I missing a step? This is just something that I wrote up off the top of my head to check my understanding of the processes needed for a successful extraction. Anything that I am over looking or forgetting?
I have all glass everything so i am not chancing stripping plastics, or whatever lye does to aluminum.
50g of caustic soda
50g of salt- non-ionized
50ml white distilled vinegar
~500ml distilled water
Place ground bark into your first mason jar, add about 200ml of water and go ahead and add 50-60ml of vinegar (trying to achieve a PH of 2) Place this mixture in a “warm” water bath for one hour, gently stirring.
While waiting on the hour to pass, go ahead and dissolve 50g of salt into a bit of water. The only point of this is so that you will not have to try to dissolve inside of the jar we are trying not to agitate to much.
After you have your dissolved salt, go ahead and slowly add it to the jar. Gently shake/swirl. Try not to make bubbles.
Next step is to add your lye(shooting for PH of 12 or higher). 50g of lye, add it to the water, not the other way around.
Then you are ready to add your organic solvent. Naptha is my choice, so slowly add about 50ml of that. Same shake/swirl method while in a warm bath. Repeat as needed ~4 runs then test the fifth by freezing it.
And upon doing this I should result in pure white crystal? Or am I missing a step? This is just something that I wrote up off the top of my head to check my understanding of the processes needed for a successful extraction. Anything that I am over looking or forgetting?
I have all glass everything so i am not chancing stripping plastics, or whatever lye does to aluminum.
