Totally out of this world

[froggydays]

Pure Vape juices, PG is PROPYLENE GLYCOL, VG is VEGETABLE GLYCERINE
There is a useful calculator here - Minty Love - JuiceBuddy1 and I'd recommend Minty's Youtube for some well thought out explanations / tutorials Minty Love

Hi Transistor Bass,

I was able to get the GeekVape as well as make the Djuice, however for the Djuice it didnt really dissolve too well. I mixed as per instructions around 500mg with 1mL of PG, but after ~10 minutes there were some big chunks in the solution, although the original powder was very fine.

Any suggestions? How do you better dissolve?

Also, the Geekvape 5 has a minimum of 70W I see, while for the Aegis 2 the recommended Watt's is 30W. Does this matter much?

Thanks!

 

[TransistorBass]

Hey.
I tend to mix mine thoroughly then leave in a warm place overnight, its always clear by the morning, mix well again before filling your Vape Tank.
I'm guessing you have a 2ml Zeus Tank, you would be best mixing up enough for 2.5-3ml so you have enough to soak the coil for 20mins before use and a bit of spare for topping up.

This is from my notes from my first juice mix:

First Vape juice mix in Geekvape Aegis Legend 3 Kit with Z0.15 Coil fitted, a juice mix of 500mg DMT with 1.75ml PG and 0.75 VG to make 3ml of D-Juice. Vaped at 20w but quickly turned up to 30watt after first toke.

You can easily just use PG and your 500mg DMT will dissolve in 2.5ml of PG making 3ml in total.

30 Watt is about perfect, close your little air holes down to be about 2-3mm open, take fairly slow deep breaths when toking from it.

Hope that helps, let me know how you get on.

 

[froggydays]

Hey.
I tend to mix mine thoroughly then leave in a warm place overnight, its always clear by the morning, mix well again before filling your Vape Tank.
I'm guessing you have a 2ml Zeus Tank, you would be best mixing up enough for 2.5-3ml so you have enough to soak the coil for 20mins before use and a bit of spare for topping up.

This is from my notes from my first juice mix:

You can easily just use PG and your 500mg DMT will dissolve in 2.5ml of PG making 3ml in total.

30 Watt is about perfect, close your little air holes down to be about 2-3mm open, take fairly slow deep breaths when toking from it.

Hope that helps, let me know how you get on.

Thanks, I've added the pg vg d mix already after around half an hour of dissolve, Minty's guide said 10 minutes should work, but I know now for next time.

Regarding the Watts, the Geekvape 5 doesn't go lower than 70w I think, is this a problem?