• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

A way to "E-mesh-fy" a dry herbs vaporizer?

windyshaman

Established member
Joined
Aug 24, 2025
Messages
80
Merits
1,262
Some context: I've been using one and as of recently - a couple of identical, portable dry herbs vaporizers for my DMT practices - for over a year now.
And I have it nailed down well enough at this point to be able to talk about repeatable results.
Now - normally - I layer spice with camomille, but lately I was eye-balling an e-mesh rig and it gave me an idea.
I sorta tried it already back when I was experimenting with a desktop setup, but it didn't do much at the time... well, the whole thing didn't do much for me - period.

So here's what I changed Today for an earlier session:
- instead of filling half the chamber with camomille - I only added a small layer of ~1/8" on the bottom (and this was more of a precaution to have something absorbing and prevent spice leakage at full temperature)
- and then I added a stack of pipe mesh screens of the exact chamber's size, about 3/4 of the way up
- added spice
- filled the rest of the available volume with more screens (not sure about the total, about 16-20 easily)

Had the temperature maxed out to 221C, let it sit for about 30-45 secs...
Inhale...
This is a little harsher than with camomille, but that first full inhale did hit so hard...

Outcome:
- I've definitely broken through on a much lower dosage than is required usually (70mg vs 100mg)
- overall today's trips felt a lot stronger
- comedown was a little more abrupt as there wasn't much left in vaporizers to surf on the way down... bone dry after a few real hits
- I'm really impressed
- will try to eliminate camomille altogether next time, see if there's any leakage from the chamber
 
Last edited:
Back
Top Bottom