• Members of the previous forum can retrieve their temporary password here, (login and check your PM).

Inoculation Problem

Migrated topic.

cannabinated

Rising Star
Joined
Sep 23, 2012
Messages
48
Merits
42
I inoculated rye grain today in my first attempt at mushroom growing. I spent about an hour sanitizing my very dirty bathroom and I was in such a rush during inoculation that I forgot to swab the area of my grain bag in which the needle made its entrance.:cry: I did the inoculation inside of a sterile plastic box. Should I expect that my bags wont be colonized?
 
Did you flame the needle red hot? If so I'd say there's a pretty good chance you'll be alright. Just gotta let it sit and wait to see
 
cannabinated said:
yes i did but i used a bic lighter and it got slightly sooty. is that too terrible?
nah its good, but not recommended.
i use iso then boiling water to rinse, but a bic should be fine.
 
You should be alright just keep covered and forgotten for a little while. One of the worst habits growers tend to have is they keep opening the container in which the jars are sealed to admire the colony's progress

give 3 weeks to a month you see pins

Good luck
 
You really don't need no stinkin alcohol burner, especially if you don't have much extra cash.

I just take a small saucer and pour a little IPA (isopropyl alcohol) where the depression for a tea cup would go.

When needed, i light that small amount of IPA, and just hold the needle over that flame, till red hot. When done with the flame, i take another small plate or the like and set it on top of the saucer, which extinguishes the flameage in short order........

Perhaps not as proper as an alcohol burner, but for me, much cheaper and works fine!!!

Just sayin............
 
Back
Top Bottom