psilocybin
Rising Star
Any questions or problems you may run into during an extraction can be asked to get other members input in this thread.
-
Members of the previous forum can retrieve their temporary password here, (login and check your PM).
official extraction help thread
- Thread starter psilocybin
- Start date
-
- Tags
- dmt
if you do that, dont forget to try to keep all of the other variables (pull size, amount of pulls, time of pull mixing, etc) exactly the same for it to be a valid comparison. If you can take pictures and later post for us, that would be very appreciated. Otherwise just telling us the results is fine too. Side-by-side tests are always very important to increase our knowledge
Good luck!
Good luck!
Shifty
Rising Star
what is the safest way to extract dmt? leaving as little solvents behind as possible, also easiest plant to obtain with the most dmt in michigan? sorry if this question is somewhere else if so link me >_< SWIM will be researching techs all night and plants so thought id get started here 
People spend many weeks/months (or years) researching this. Its a very important deep thing to extract and take these substances, not something that you decide overnight. So if someone comes here and says they researched for one night and asks questions like 'what is the easiest safest best way for most dmt' kind of questions, then it doesnt sound too good, does it? We cant spoonfeed you information (no offense meant). Please look further. Here's a good start.
SWIM wants to transcend the ego and the body and SWIM think dmt might help with this.
SWIM don't know if this has a name but it's basically layzyman's tek i guess.
But it happens that SWIM has easier access to heptane of higher quality than the naptha(zippo brand lighter fuel).
SWIM also wants to do freeze precipitation. SWIM thinks it will be easier.
Should SWIM heat the NaOH/MHRB mixture before the first pull?
Beacause as he understands it doing it with cold water will give purer crystals, and higher temp means higher saturation in the heptane.
Can't he do several pulls with cold water?
Thanks
SWIM don't know if this has a name but it's basically layzyman's tek i guess.
But it happens that SWIM has easier access to heptane of higher quality than the naptha(zippo brand lighter fuel).
SWIM also wants to do freeze precipitation. SWIM thinks it will be easier.
Should SWIM heat the NaOH/MHRB mixture before the first pull?
Beacause as he understands it doing it with cold water will give purer crystals, and higher temp means higher saturation in the heptane.
Can't he do several pulls with cold water?
Thanks
yep he can. Just dont throw the mimosa away till final yield as achieved becuase if is low yield, then you know there is more pulls to be done 
R4s3tsu
Rising Star
Hello,
I've done some extractions and finally successfuly get proper crystalls! A\B tek works just great, very clean and beautiful yeld. I've used A\B and take a cup with naphta to the dark place for several days. And then I was very surprised when I looked at the cup with naphta - there was huge spiky crystalls, almost transparent in color and above 1cm in size.
I've notice strange thing: When I pull out and clean naphta it became transparent, but when I blowing into the jug with naphta, a white clouds starts to appear, what is that? DMT? Looks like it's droping off or became insoluable here, after few seconds clouds are dissapering again. I think it maybe usefull trick for extraction, huh?
I've done some extractions and finally successfuly get proper crystalls! A\B tek works just great, very clean and beautiful yeld. I've used A\B and take a cup with naphta to the dark place for several days. And then I was very surprised when I looked at the cup with naphta - there was huge spiky crystalls, almost transparent in color and above 1cm in size.
I've notice strange thing: When I pull out and clean naphta it became transparent, but when I blowing into the jug with naphta, a white clouds starts to appear, what is that? DMT? Looks like it's droping off or became insoluable here, after few seconds clouds are dissapering again. I think it maybe usefull trick for extraction, huh?
stolpioni
Rising Star
So I've just done the Lazy Man's Tek and now have a jar full of black liquid in my bathtub.
My question is, how am I supposed to get the naphta (that is the top layer?) onto a plate or similar?
When I tried to pour the liquid onto a plate, everything (including the black liquid) went to the plate.
My question is, how am I supposed to get the naphta (that is the top layer?) onto a plate or similar?
When I tried to pour the liquid onto a plate, everything (including the black liquid) went to the plate.
This is harder and takes longer than swim thought
Swim is pissed and is not listening to reason
I hope
Swim doesn't go and do something stupid
First swim tried the good ol ab w lye n naptha
Using 160g mhrb following the tek exactly except swim reduced the aqueous volume to much and burnt a little before adding lye
Not to many xtals after three pulls prob half g by eye
Swim wonders why
Can aqueous volume be reduced too much?
Maybe the final mix was not agitated enough
The main problem is recovering the x tals after freeze
The container was left to fully dry in the sun after being thoroughly poured off and since it is super humid here large amounts of condensation occured and swims precious spice is redisolved in water and amlil naptha
Swim is also cooking a littlle over a
Lb mhrb at the moment and plans to reduce much farther than the tek calls for to fit in his wine jug. Oh and lb can't be decanted over night still looks like reddish chocolate milk. If it doesn't clear soon it's going through a tshirt.
Swim is pissed and is not listening to reason
I hope
Swim doesn't go and do something stupid
First swim tried the good ol ab w lye n naptha
Using 160g mhrb following the tek exactly except swim reduced the aqueous volume to much and burnt a little before adding lye
Not to many xtals after three pulls prob half g by eye
Swim wonders why
Can aqueous volume be reduced too much?
Maybe the final mix was not agitated enough
The main problem is recovering the x tals after freeze
The container was left to fully dry in the sun after being thoroughly poured off and since it is super humid here large amounts of condensation occured and swims precious spice is redisolved in water and amlil naptha
Swim is also cooking a littlle over a
Lb mhrb at the moment and plans to reduce much farther than the tek calls for to fit in his wine jug. Oh and lb can't be decanted over night still looks like reddish chocolate milk. If it doesn't clear soon it's going through a tshirt.
all right, the redisolved xtals were evaporated as best as possible then redisolved in hot 1/2 naptha 1/2 basic solution and stirred around
hopefully any remaining water went into the basic solution and any spice went into napptha
the basic solution was pulled out from under the naptha and added back to the total volume.
the total volume was reheated in a crock and then poured into jug and another pull was done with 200 ml to make sure as much as possible of the remaining spice is pulled
the 200 ml was reduced to 30 ml using a clean and dry crock.
this was added to the naptha that the xtals were redisolved in to make 90 ml
5 hours of freezing temps later there are way less xtals than before like 1/4th!
what gives?
Swim doesn't care about this extraction so much but he has done two boils on 540 g mhrb of 4 liters each and has reduced the first boil to 2 liters
the second boil is still in the fridge because it still looks like red choco milk
Swim would like some advice before proceeding
Does the volume of water per amount of mhrb matter alot?
How much can swim reduce the volume after straining before yeild suffers? ( it would be nice if it fit in the wine jug instead of trying to shake a 5 gal carboy w/ no top!)
will the cloudy liquid cause emulsions if it is strained through a t-shirt?
hopefully any remaining water went into the basic solution and any spice went into napptha
the basic solution was pulled out from under the naptha and added back to the total volume.
the total volume was reheated in a crock and then poured into jug and another pull was done with 200 ml to make sure as much as possible of the remaining spice is pulled
the 200 ml was reduced to 30 ml using a clean and dry crock.
this was added to the naptha that the xtals were redisolved in to make 90 ml
5 hours of freezing temps later there are way less xtals than before like 1/4th!
what gives?
Swim doesn't care about this extraction so much but he has done two boils on 540 g mhrb of 4 liters each and has reduced the first boil to 2 liters
the second boil is still in the fridge because it still looks like red choco milk
Swim would like some advice before proceeding
Does the volume of water per amount of mhrb matter alot?
How much can swim reduce the volume after straining before yeild suffers? ( it would be nice if it fit in the wine jug instead of trying to shake a 5 gal carboy w/ no top!)
will the cloudy liquid cause emulsions if it is strained through a t-shirt?
jblazingnataraja
Rising Star
I am wondering whether I can use CaCO instead of NaCO for the wash - I have some lying around from a while ago, and thought I could maybe put it to good use.
Yes? No??
Yes? No??
no
you can easily find sodium bicarbonate in pharmacy or supermarket or wherever, and turn it into sodium carbonate by baking it in the oven on high for 2 hours.
you can easily find sodium bicarbonate in pharmacy or supermarket or wherever, and turn it into sodium carbonate by baking it in the oven on high for 2 hours.
neverwas
Rising Star
sorry but I have to do this. I need info's ASAP. check out my last 2 posts. Q21Q21 in progress
The stuff is still moving around if I swirl the naphtha and isn't really crystalline. I didn't re-heat and dissolve naptha/DMT. Am I supposed to? I'm so frustrated...
The stuff is still moving around if I swirl the naphtha and isn't really crystalline. I didn't re-heat and dissolve naptha/DMT. Am I supposed to? I'm so frustrated...
fraterS.O.L.
Bill Nye
^^ What sort of tek were you using? a/b, stb? Its hard to tell what the problem is?
morbiddoctor-I think as long as your xtals get dry this time that your good to go. If you want to clean them up more try a recrystalisation with bestine.
Love & Peace
morbiddoctor-I think as long as your xtals get dry this time that your good to go. If you want to clean them up more try a recrystalisation with bestine.
Love & Peace
