Boiling ACRB with a ph2.5

[MoHaN]

Hey, I am at the moment boiling ACRB with a ph2.5 from kangen water. I have some questions.
Could I drink the tea? Would it be active?
What would be the next steps if I would like to yield alkaloids from it?
Also could the remains, the barks, be smoked in a bong to get any kind of visuals dmt spoken?
I tried it dry and had some mild effects but I have a bad habit of smoking cigarettes which I hope dmtaya will help me quit.

Cheers

 

[Elrik]

If your water and acid are safe for consumption and the tea is pH 2 or higher, yes, you can predose with harmalas and then drink the tea. Stir it up to get sediment evenly distributed and drink the tea anywhere from cold to luke warm. Only drink it hot if you like vomiting a bit too much
If you wanted alkaloids, there are a variety of teks here. At the most basic you would concentrate the tea down some by boiling, cool it, add a strong base like lye until pH is well over 10 [this heats it up again], extract with an organic solvent, and extract the alkaloids from the organic solvent. If the solvent is something like toluene or xylene you'd extract the alkaloid with dilute aqueous acid, if the solvent was hot naphtha or hot heptane just putting it in the freezer will crystallize out smokable alkaloid base. Like I said, there are loads of methods written out here.
The boiled bark is not smokable, if you boiled it well there should be no goodies left in it.

 

[MoHaN]

Thanks for the reply elrik, I was having a chat earlier in that chat section and the idea of boiling the harmalas came to mind after several members told me so. Should this be done like having two drinks or just mixing the Syrian rue with the tea from the root bark with ph 2.5?