Hello, it’s my first posting anything be gental ya’ll. I have a question why can’t you add your napthia (I use crown camp fuel less oils and distillates ) while the soup is still warm ? I add my Noah solution while the soup was warm and the naphtha to the warm soup (and it’s like a reaction reminds me of the red tek for well you know smells like it too it has the whippets or bubbles forming when you heat it up ) set it in the hot water bath. I also clean my finished product that is aliiite gooey I use hot hot napthia I pour it into a porcelain evaporator dish and what dissolves which is 75%of it, I precipitate and what’s left in the dish I dry out and it’s still good. More thing too I pre freeze my Pyrex so when I pour it off into the frozen plate it instantly freebases. Am I doing it right everyone around me loves it when I do it I think I see incentives don’t think I’m crazy kinda like trying to get me in like jack hammering my head not with bad intent one time I believe it look at it’s wrist and said it’s about time what took you so long idk idk any suggestions oh and what’s up with the adding of the salt now it’s been a minute
-
Members of the previous forum can retrieve their temporary password here, (login and check your PM).
Acrb questions and maybe some wisdom
- Thread starter Breezy
- Start date
Make sure you have and are actively using a fume hood; you WILL blow up if you are not outside doing this. Just use VM&P, in my opinion, but to each their own.
Hydrotreated light petroleum distillates are harder to evaporate than naphtha, and naphtha already takes a while when getting goop from soaps ( when using acrb you will get goop as the NMT content is much higher, 45% to 55% DMT, in contrast to mimosa, which is nearly all DMT.) Hydrotreated light petroleum distillates do not evaporate at room temperature. Attempting to force evaporation via heat will leave behind heavy, toxic, oily petroleum residues that will permanently contaminate the sticky NMT/DMT mixture, making it entirely unsafe for any form of consumption.
Pentane and Isopentane are most likely causing the bubbles, as they are highly volatile and have a low boiling point. These gases will collect on the floor in an enclosed room and are VERY flammable and quite dangerous. The smell of whippets when working with these are most likely due to them. They require respirators, and if you can smell it, your ventilation isn't good enough.
Please always read the MSDS of all chemicals you work with, its always nice to see a yield, but its nicer to be safe. For your question of if your doing it right, you should be following a guide that has every step written word for word, if there are steps you dont understand or aren't communicated properly, find a better guide.
im not understanding the salt questions and the jackhammering part.
but for the salt your either refering to turning the fb into a salt or adding standard salt to fix and emulsified soup
. Turning DMT freebase into dmt citrate or fumarate salts. The salt version is more stable and will not degrade as fast in similar conditions; this allows more DMT to make it to your lungs without breaking down and increases shelf life.
Hydrotreated light petroleum distillates are harder to evaporate than naphtha, and naphtha already takes a while when getting goop from soaps ( when using acrb you will get goop as the NMT content is much higher, 45% to 55% DMT, in contrast to mimosa, which is nearly all DMT.) Hydrotreated light petroleum distillates do not evaporate at room temperature. Attempting to force evaporation via heat will leave behind heavy, toxic, oily petroleum residues that will permanently contaminate the sticky NMT/DMT mixture, making it entirely unsafe for any form of consumption.
Pentane and Isopentane are most likely causing the bubbles, as they are highly volatile and have a low boiling point. These gases will collect on the floor in an enclosed room and are VERY flammable and quite dangerous. The smell of whippets when working with these are most likely due to them. They require respirators, and if you can smell it, your ventilation isn't good enough.
Please always read the MSDS of all chemicals you work with, its always nice to see a yield, but its nicer to be safe. For your question of if your doing it right, you should be following a guide that has every step written word for word, if there are steps you dont understand or aren't communicated properly, find a better guide.
im not understanding the salt questions and the jackhammering part.
but for the salt your either refering to turning the fb into a salt or adding standard salt to fix and emulsified soup
. Turning DMT freebase into dmt citrate or fumarate salts. The salt version is more stable and will not degrade as fast in similar conditions; this allows more DMT to make it to your lungs without breaking down and increases shelf life.
SashaThuh2nd
What was that?
That camp fuel will work, don't forget to purify the crystals with heptane though.
Similar threads
