TEK "TnT tek" - Vodka DMT extraction for oral use TEK (super easy!)

[Pyramids]

Well, although I never took it as far as correcting the volume to standardise the dosing (which would be sensible), it would be quite viable just to use vodka if your material was evaporated down to an essentially solid mass, but I'd consider using higher-proof alcohol if it was only partly evaporated down to a liquid, since alcohol evaporates faster than water.

very much appreciated. i'll build a statue in your honor in the dmt world

 

[Pyramids]

I just concluded my second test with this first run (using different batches of caapi) and it appears i messed up somewhere as I can barely feel the dmt at a 7g dose (plus 5g 1hour later). The only variation from the tek was that i couldn't figure out how to effectively filter the sludge, so I just decanted the clear liquid. Otherwise I followed it exactly (leaving the MHRB in vodka for 3 days or so). This was using a known strong batch of MHRB. Any thoughts appreciated, thanks.


"Freebase DMT is highly insoluble in water. Because vodka is 60% water, raising the pH actually forces a large portion of the DMT out of the liquid solution, causing it to trap itself in the sludge at the bottom." Don't know if it's true or not, but this may explain it. That sludge is really not filterable...

 

[Transform]

Freebase DMT is highly insoluble in water. Because vodka is 60% water, raising the pH actually forces a large portion of the DMT out of the liquid solution, causing it to trap itself in the sludge at the bottom." Don't know if it's true or not, but this may explain it. That sludge is really not filterable...

I'm guessing that's a LLM ("AI") output. Practical experience shows that DMT freebase is highly soluble in vodka.

How much lime, proportionally, did you use?

 

[Pyramids]

I'm guessing that's a LLM ("AI") output. Practical experience shows that DMT freebase is highly soluble in vodka.

How much lime, proportionally, did you use?

ok, cool. I used 115g of lime.

Everything looked exactly like the pictures posted by Ambrosaure. I'm assuming you've read through his write up and all is as it should be. it's a remarkably simple tek, so i'm not sure on how/where it could have gone wrong